Page 1 of 1

Calibrating bar specialised barcode printers - Feed Button

Posted: February 12th, 2017, 9:53 am
by basit
Calibrating the Printer Using the Feed Button

The desktop printers can be sent commands by using the top feed button. This is done by various “Flash Sequences” that are sent by holding the top button down for a certain amount of time.

To send a calibrate command to the printer, hold the feed button down on the printer. The green light will first flash once, then flash twice. If you release the button after the green light flashes twice, a few labels will feed from the printer and it will re-calibrate to your label stock.

More info on printing visit http://barcode-labels.com/technical-sup ... ender-faq/